1、 The cost difference is not big, but the thickness of thin layer masonry mortar mortar joint is about 1 / 3 of the traditional one, which not only saves materials. It is more in line with the national general direction of improving building energy efficiency and building a conservation oriented society.

二、质量对比

2、 Quality comparison

薄层砌筑砂浆，保水好，砌块可以不用洒水。

Thin layer masonry mortar, good water retention, block can not spray water.

三、施工方式

3、 Construction method

普通砌筑砂浆：基材表面的杂质清理，砖块施工前必须洒水；砌筑时应上下错缝，施工厚度在15-20mm。

Common masonry mortar: the impurities on the surface of the base material shall be cleaned, and the bricks shall be watered before construction; The masonry should be staggered up and down, and the construction thickness should be 15-20 mm.

薄层砌筑砂浆：基材表面的杂质清理，砖块施工前无须洒水；砌筑时应上下错缝，施工厚度在3-5mm。

Thin layer masonry mortar: the impurities on the surface of the base material shall be cleaned, and there is no need to spray water before the brick construction; The masonry should be staggered up and down, and the construction thickness should be 3-5mm.

薄层砌筑砂浆

Thin layer masonry mortar

四、结论分析

4、 Conclusion analysis

普通砂浆一般都是搅拌站运输到工地后使用，常常会有因为算方不准或者因为施工慢，造成会剩下一定的尾浆，由于监管不到位，很多尾浆私自用于施工。这些尾浆很容易对工程质量造成危害。

Ordinary mortar is generally used after the mixing station is transported to the construction site. Due to the inaccurate calculation or slow construction, there is a certain amount of tail slurry left. Due to the lack of supervision, many tail slurry is used for construction privately. These tailing slurries are easy to cause harm to the engineering quality.

而薄层砌筑砂浆完全是由工地工人自己加水搅拌施工的，做多少用多少，可以完全杜绝尾浆的使用。其使用简单，施工速度快，而且施工质量也有一个较大保证。

The thin layer masonry mortar is completely mixed with water by the workers on the construction site, so the use of tail slurry can be completely eliminated. Its use is simple, construction speed is fast, and construction quality also has a big guarantee.