In order to ensure the completion of gypsum powder construction, it is necessary to strictly follow the implementation standards. For the implementation standard of gypsum powder construction, we also collated some information.

　　首先，脱硫石膏粉生产设备施工前对基层的处理是极有必要的，要确保基层平整，如有凹凸不平处需及时处理;根据基层墙面的吸水率进行湿润，待表面无浮水再进行抹灰施工。

　　First of all, it is very necessary to treat the base before the construction of desulfurization gypsum powder production equipment. It is necessary to ensure the level of the base, if there are bumps, to deal with them in time; wet the base wall according to the water absorption rate, and then plaster the surface without floating water.

　　用石膏粉配制的砂浆的抹灰工艺与传统抹灰工艺相同，需要按规定挂线，找规矩进行墙面抹灰。石膏粉的具体施工方法如下所述：

　　The plastering process of mortar prepared with gypsum powder is the same as that of traditional plastering process. It needs to hang wires according to the regulations and find rules for wall plastering. The concrete construction method of gypsum powder is as follows:

　　1根据设计要求、工程造价等实际情况来选择底层砂浆配合比，然后进行墙面抹灰。

　　1. Select the mix proportion of bottom mortar according to the design requirements, engineering cost and other actual conditions, and then carry out wall plastering.

　　2按传统工艺对内墙及顶棚进行抹灰刮糙，依据标志及标筋用刮杠刮平，后用木砂板搓平压实。

　　2. According to the traditional technology, plastering and scraping the interior wall and ceiling, scraping with scraper according to the sign and reinforcement, and finally rubbing and compacting with wood sand board.

　　3脱硫石膏粉生产设备可采用净浆或混合料浆作为面层抹灰材料，用水量要以适应气候条件、便于施工为宜。拌灰量要适宜，确保当天能用完，避免造成浪费。在底层砂浆差不多七八成干时进行面层抹灰，用铁板压实压光。

　　3. Clean slurry or mixed slurry can be used as surface plastering material for desulfurization gypsum powder production equipment. The water consumption should be adapted to climatic conditions and convenient for construction. The amount of ash mixing should be appropriate to ensure that it can be used up on the same day, so as to avoid waste. When the bottom mortar is about 78% dry, the surface is plastered and compacted with iron plate.

　　4等面层抹完12-24小时后，用细砂纸将表面纹路抹平，再用湿布擦洗一遍便可达到中高级抹灰标准。

　　4. After 12-24 hours of plastering, the surface lines are smoothed with fine sandpaper, and then scrubbed with a wet cloth to reach the intermediate and advanced plastering standards.

　　今天的内容就先为大家介绍到这里了，如果您有济南石膏粉的其它疑问，欢迎您点击我们的官网进行咨询：//www.gochiism.com/

　　Today's content is introduced here. If you have any other questions about Jinan gypsum powder, you are welcome to click on our official website for consultation: //www.gochiism.com./